Manage NAT QoS

You can use Quality of Service (QoS) traffic shaping parameters to limit the bandwidth for all the NSX-T NAT IPs in a virtual datacenter. 

When you create a virtual datacenter, the new natbandwidthlimit attribute is present but you must edit the virtual datacenter to activate it in the platform and in the NSX-T. 

Open

A virtual datacenter with a NAT bandwidth limit for QoS

To edit the bandwidth limit and apply it in the NSX-T:

1. Select the virtual datacenter 

2. Go to Network → QoS

3. Click the pencil edit button 

   1. The Provider ID will identify the virtual datacenter

   2. To activate the bandwidth limit in a specific direction, select the Enabled checkbox for that direction

   3. Set QoS values for your virtual datacenter. Be sure to allow enough bandwidth to share between all the NAT IPs in the virtual datacenter.

   4. For the Average enter the the average amount of bandwidth, in bits per second, that the virtual datacenter can use

   5. For the Peak enter the maximum bandwidth in bits per second that the virtual datacenter can use

   6. For the Burst size enter the amount of data that can be transmitted at the peak bandwidth rate in bytes. A burst bonus accumulates when traffic is below the Average value and this bandwidth can be used for bursts.

Open

Edit the NAT QoS values for the VDC

To register changes that were made outside the platform, save the existing NAT bandwidth values. In the API, to register changes, send a POST request with the existing values.