| Table of Contents |
|---|
This page is a quick general guide only and you should always consult the Zerto documentation.
Introduction to Zerto test environment
This page describes a basic environment that is suitable for testing Zerto with Abiquo. You will find full instructions in this Zerto Documentation, which was linked at the time of writing.
We configured a test environment similar to the one shown in the Architecture diagram from the Installation guide.
%20-%20vSphere%20Online%20Help/Content/Resources/Images/Architecture/Architecture_Enterprise.png){kind=link}
The following configuration is for a test environment only and we recommend that you also configure your firewall and ports and communications according to the Zerto documentation.
Windows 2019 - Zerto 01A is attached to the standard network ZNETZerto Replication Network.
Windows 2019 - Zerto 02A is attached to the standard network VM NetworkNetwork
Install Zerto Virtual Manager
...
The VM requires at least 1GB RAM and 1 x vCPU, and you must attach it to a ZNET network in the Zerto Replication Network in the vCenter.
You also need to assign an IP, Subnet Mask, Default Gateway, and the datastore.
...