| Table of Contents |
|---|
This page is a quick general guide only and you should always consult the Zerto documentation.
Introduction to Zerto test environment
This page describes a basic environment that is suitable for testing Zerto with Abiquo. You will find full instructions in this Zerto Documentation, which was linked at the time of writing.
We configured a test environment similar to the one shown in the Architecture diagram from the Installation guide.
%20-%20vSphere%20Online%20Help/Content/Resources/Images/Architecture/Architecture_Enterprise.png){kind=link}
The following configuration is for a test environment only and we recommend that you also configure your firewall and ports and communications according to the Zerto documentation.
In our test environment we configured two VMs with Windows Server 2019 - Zerto 01A is and attached them to the standard network Zerto Replication Network and the Management network.
Windows 2019 - Zerto 02A is attached to the standard network VM Network
Install Zerto Virtual Manager
...
The VM requires at least 1GB RAM and 1 x vCPU, and you must attach it to the Zerto the Zerto Replication Network in Network in the vCenter.
You also need to assign an IP, Subnet Mask, Default Gateway, and the datastore.
...