Versions Compared

Old Version 1

changes.mady.by.user MS

Saved on

compared with

New Version 2

changes.mady.by.user MS

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: 4.2.2 - 10157 - Remove public-network-cidr as NAT IP must be used

...

NameDescription
abiquo.nsx.transport-zoneThe transport zone where the networks created by Abiquo will be attached.
abiquo.nsx.edge.cluster-idIdentifier (in VCenter) of the cluster where Abiquo will deploy the ESG.
abiquo.nsx.edge.datastore-idCSV list of identifiers (in VCenter) of the datastores where Abiquo can deploy the ESG appliances according to the datastore-policy
abiquo.nsx.edge.datastore-policy

Allocation policy for selection of datastores to deploy ESG appliances.
Default: leastvms
Range: leastvms, mostspace

abiquo.nsx.edge.public-network-cidrNetwork range where the "public" load balancer IPs will be taken from. It must be a range dedicated to Abiquo.abiquo.nsx.load-balancer-reserved-ips

Number of IP addresses that are reserved for NSX in each private network to allocate to load balancers. Default: 20
The gateway can be address 1. The reserved IPs range starts from address 2 for the number of IPs configured by the user, by default, up to address 21
Users should work with automatic IP allocation. In any case, the system administrator should inform the users of the range and by default, the first free address is address 22 

abiquo.nsx.edge.plr-esg-idID of the Edge that acts as the PLR.
abiquo.nsx.edge.plr-transit-cidrCIDR for the transit network network to be used between the PLR and the Edges of each Abiquo Virtual Datacenter.
abiquo.nsx.edge.plr-transit-ipIP address from the PLR transit network to be assigned to the PLR. If not set, the first IP address in the network will be assigned.

...

To configure properties globally in the DC Remote Server properties, use them with an abiquo. prefix:

NameDescription

nsx.virtualwire.teaming  

Use this property to set the teaming policy for the portGroup that is the backing for the VirtualWire when it is created. This value cannot be changed after it is created.
Default: "failover_explicit"
Values: "failover_explicit", "loadbalance_ip", "loadbalance_loadbased", "loadbalance_srcid", or "loadbalance_srcmac"

nsx.edge.esg.size

Size of the ESG appliances.

Values: compact, large, quadlarge, xlarge

nsx.edge.descriptionDescription to configure in the edges created by Abiquo.